GATOR POLYMERS, LLC
CAPE CORAL, FLORIDA

At Gator Polymers, we specialize in electronic and plastic pre-form insert injection molding of components into an environment resistant, aesthetic and functionally pleasing package. Whether it is metal, plastic, printed circuit boards or other insert-able components, Gator Polymers takes customer designs and ideas and makes them a reality. Gator Polymers will take your design and build mold(s) to meet your specifications. Our goal is to deliver on time and within budget. Gator Polymers also specializes in conventional contract injection molding of small, high tolerance conventionally molded plastic parts. Small to very large runs are standard for Gator Polymers. Parts are made in single, dual or multiple cavity molding configurations dependent upon customer requirement. Gator Polymers employs multiple unit dies to lower the costs of die removal and setup. Standard sizes of dies are 5"x5" or 11"x11". Gator Polymers has standardized on the newest most modern equipment utilizing full feedback and thorough control of all molding parameters.   Featuring ANSYS DesignSpace simulation software Gator Polymers has ANSYS® DesignSpace® as a service to its customers which is charged at a low hourly rate. ANSYS® DesignSpace® is a simulation software package that gives Gator Polymer engineers the power to conceptualize, design, and validate ideas prior to going into production. Our service is geared to aid our customers early in the design stage when making changes to part design and assemblies are most flexible; including step by step structural, thermal, dynamic, weight optimization, performance optimization, vibration mode and safety factor simulations as they relate to part design and assemblies. For more concerning the advantages to the procedure, please visit Welcome to Gator Polymers At Gator Polymers our specialty is insert-molded plastic components made to your specifications . Whether it is metal, plastic, printed circuit boards or other insert-able components, Gator Polymers can design and build the mold to meet stringent customer specifications, deliver on time and within budget. Gator Polymers also specializes in contract injection molding of small, high tolerance and insert-molded plastic parts made to exacting customer specifications. Small runs or production runs to millions of parts are standard for Gator Polymers. Parts are made in single, dual or multiple cavity molding configurations dependent upon customer needs. Gator Polymers employs multiple unit dies to lower the costs of die removal and setup. Standard sizes of dies are 5"x5" or 11"x11". Gator Polymers has standardized on the newest most modern equipment utilizing full feedback and through control of all molding parameters. © 2012 All Rights Reserved - Gator Polymers | 3302 SE 22nd Avenue, Cape Coral, FL 33904